![]() The latest update is written and installed over the currently installed program. To update ARUA-10, execute the same procedure as used for installation, and follow the instructions that appear on the display to install the software. In the designated folder, a folder labeled "ARUA10_400" will be created.Įxecute the "Setup.exe" in the folder labeled "ARUA10_400", and follow the instructions that appear on the display to install ARUA-10.Īdministrator privileges are required when installing the software. While the media in which the software is stored is possessed by the user, the ownership for the software itself shall be reserved for JVC KENWOOD.Įxtract the downloaded file "ARUA10_400.zip" into a designated folder. The user shall be allowed to use, not to resell, the software by obtaining a license from JVC KENWOOD. JVC KENWOOD shall own all copyrights and other intellectual properties for the software and all manuals and documents attached to the software. JVC KENWOOD Corporation shall be free from any responsibilities for any incidental losses or damages, such as missing communications or a calling opportunity caused by a failure or performance error of this Software. The User shall take full responsibilities for the ![]() Selection and installation of this software shall be made by the User's designation. JVC KENWOOD does not warrant that quality and functions of this software comply with each user's purpose of use of this software, and unless specifically described in this document, JVC KENWOOD shall be free from any responsibilities to any defects and indemnities to any damages or losses. Users are prohibited to revise, change, translate, merge, de-compile, or reverse engineer the software. Users are prohibited to assign, rent, lease, redistribute, or resell the software. * Download and install the virtual COM port driver to make a USB connection possible for command communications via a USB connector.Ī speaker and a microphone.(Or a headset.) ARUA-10 may not behave properly if a connection is in place through a USB hub. * If the transceiver is connected to a PC using a USB cable, ensure that the connection is directly in place. NET 2.0 and 3.0).Ī display with resolutions higher than XGA (1024 x 768).Ī keyboard and a mouse, or other pointing devices. Larger than the recommended System Memory for each OS. (Noted on June 23, 2022)Īpplicable operating systems are subject to change without notice due to the end of the technical support by Microsoft Corporation or change of the product specifications.įaster than the recommended CPU for each OS. This software is designed to run on the above operating systems. Windows ® 8.1 (RTM or later) (32-bit or 64-bit) Windows ® 7 (SP1 or later) (32-bit or 64-bit) TS-590S USB Audio Setting Manual : (525KB PDF). TS-590SG USB Audio Setting Manual : (506KB PDF). TS-890S USB Audio Setting Manual : (659KB PDF). TS-990S USB Audio Setting Manual : (580KB PDF). Please refer to the following manuals for details. The ARUA-10 will not be used while USB Audio function of the transceiver is in use in data communications such as JT65, FT8, or KENWOOD NETWORK COMMAND SYSTEM remote operations. Using this software coupled with ARCP-990, ARCP-890, ARCP-590G, or ARCP-590, simply connecting a PC to a transceiver using a USB cable makes it possible to control the transceiver from the PC.Ī virtual COM port driver needs to be installed onto the PC to use Radio Control Program ARCP-990, ARCP-890, ARCP-590G, or ARCP-590 with the USB cable. This is the software to be used to connect a TS-990S, a TS-890S, a TS-590SG, or a TS-590S transceiver and a PC by a USB cable and make it possible to use a speaker and a microphone on your PC instead of those on the transceiver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |